HonestHomeCost
Foundations

How much does sump pump installation cost?

Short answer

Fixr (updated January 31, 2025) puts sump pump installation at $800 to $2,000 with a national average of $1,400. This Old House (updated March 11, 2026) gives the same $1,400 average but prints the typical range as $500 to $4,000. Those two endpoints are not a second opinion. Fixr defines $500 and $4,000 as its own best and worst case scenarios, and This Old House states in a footnote that its cost data came from Fixr and Angi. The working figure is $1,400, and the band most homeowners land in is Fixr's $800 to $2,000.

$1,400
National average, the same figure in both guides (Fixr, This Old House)
$800 to $2,000
The range most homeowners pay (Fixr)
$500 to $4,000
The range printed as typical, which is Fixr's best and worst case (This Old House)
$350 to $1,000
Replacing a pump in an existing basin, materials and labour (This Old House)

The two guides are one guide

Source Average Printed as the typical range Updated
Fixr $1,400 $800 to $2,000 January 31, 2025
This Old House $1,400 $500 to $4,000 March 11, 2026

This Old House carries a footnote on the page: "The cost data featured in this guide was sourced from Fixr and Angi, unless otherwise noted." That is the publisher telling you itself, and it settles what would otherwise be guesswork. Two guides agreeing on $1,400 is one guide quoted twice.

The unit tables say the same thing. Both price a pedestal pump at $80 to $800 and a submersible at $90 to $1,000, digit for digit.

Where the wide range comes from

This is the part worth carrying away, because it changes what the number means.

Fixr prints $800 to $2,000 as the national average range, then separately describes two scenarios. Its low cost of $500 is a new pedestal pump dropped into an existing pit with minimal labour. Its high cost of $4,000 is a new pit with two pumps, underground drainage, battery backup and a pump alarm, drilling into a thick concrete slab.

This Old House prints those two scenario endpoints as the range most homeowners pay.

Our arithmetic, marked as ours. Fixr's typical band is $1,200 wide. The band printed as typical by This Old House is $3,500 wide, which is 2.92 times as wide. Nothing in the underlying data changed. A best case and a worst case were relabelled as a normal case.

So when a range looks generous, ask what its two ends describe. Here one end is a pump swapped into a hole that already exists, and the other is a two-pump system cut into a concrete slab. Almost nobody is at either end, which is the point of a typical range.

What actually moves your price

The decisive question is whether you already have a basin and drainage, because that is the difference between plumbing and construction.

Job Cost Source
Replacing a pump in an existing basin $350 to $1,000 This Old House
Installing a sump basin, labour only $500 to $1,200 This Old House
Drilling through a concrete foundation $2,500 to $5,000 This Old House
Labour, pump and drainage pipes $300 to $4,000 This Old House
Discharge pipe above ground $150 to $400 This Old House
Discharge pipe buried $250 to $2,000 This Old House

This Old House puts a plumber at $75 to $150 per hour where a basin already exists, and says installation may cost as little as $500 in that case.

Our reading. The basin, not the pump, is the project. A pump is a few hundred dollars of hardware; cutting a lined pit into a concrete floor and connecting it to drainage is the work. That is why the same page can honestly say $500 and $4,000 about the same appliance.

Where this sits in the drainage question

A sump pump is the last stage of a drainage system, not the system. This Old House prices French drains at $2,800 to $6,500 on this same page, as the collection side that feeds the pit, and our French drain page looks at how those figures are built.

If water is reaching the slab at all, the question upstream of the pump is our basement waterproofing page, and if the water is arriving off the roof line it is our gutters section.

What to take from this

  1. $1,400 is one number, not two. This Old House names Fixr and Angi as its sources in a footnote on the page.
  2. $800 to $2,000 is the band Fixr actually describes as typical.
  3. $500 and $4,000 are scenarios, a swap into an existing pit and a two-pump system cut into a slab.
  4. Ask about the basin first. Replacement is $350 to $1,000; a new pit through concrete is $2,500 to $5,000.
  5. A wide range is a claim about scope, and it should come with the two jobs that define its ends.

If a pump is already in the basin and you are pricing its successor rather than a first installation, that is the cheaper job and it has its own page: sump pump replacement cost.

And if the house is not on mains drainage, the pump is only part of what the ground has to handle. Our septic section covers the rest, including what a system inspection covers.

Sources

  1. This Old House, How Much Does Sump Pump Installation Cost? (2026), updated March 11, 2026 (the $1,400 average, the $500 to $4,000 range, labour, replacement, basin, concrete drilling and discharge pipe figures, and the footnote naming its data sources)
  2. Fixr, How much does it cost to install a sump pump?, updated January 31, 2025 (the $800 to $2,000 national average range, the $1,400 average, and the low-cost and high-cost scenarios that define $500 and $4,000)

Price figures are national US ranges from the sources above as of the date shown. Your local price depends on labor rates, permits and site conditions. Read how we get our numbers.