HonestHomeCost
Topic

Foundations

Repair, waterproofing, drainage and slabs, with the published averages taken apart: what they cover, what size of job they assume, and where they came from.

This section opened on 6 November 2026 and has nine pages. It works the way the rest of the site does: every figure names the guide it came from and the date that guide was updated, and where sources disagree we show the disagreement instead of splitting the difference.

One thing recurs across every page here and is worth saying at the front. Foundation work is priced per square foot, per linear foot or per repair method, and the published averages are totals that hide which of those they assume. Two guides agreeing on a total can be further apart than two guides whose totals differ threefold, once you ask how big a job each was describing.

The questions so far

Page The short answer What it adds
Foundation repair cost about $5,200 two publishers within one percent of each other at every point, with neither naming a source, and a method range from $250 to $23,000 that the average hides
Basement waterproofing cost $5 to $13.64 per square foot the outlier is the only one that says how big a basement it is pricing, which turns a threefold gap into a third
Concrete slab cost $4 to $8 per square foot for flatwork, $4 to $14 for a foundation one word covering two jobs, and a headline total that is simply the rate times 900 square feet
French drain cost $50 per linear foot inside, about half that outside a $500 to $18,000 range that turns out to be one publisher's best and worst case, printed by the other as typical
Slab leak repair cost one leak repaired is $2,300 by one guide, $2,500 by the other two guides that genuinely differ, and a rerouting ceiling of $15,000 that neither headline range includes
Sump pump installation cost $1,400 the publisher states in a footnote that its figures came from the other publisher, and the ranges show it
Mold inspection cost $500 by one guide, $656 by the other one guide's cheapest and dearest defined jobs, $300 and $1,000, bracket the range the other prints as normal
Mold remediation cost $10 to $25 per square foot two of the three averages are the same Angi data arriving twice, with identical location tables to prove it
Sump pump replacement cost $350 to $1,000 in an existing basin the replacement motor costs more than a whole new pump, which settles the repair or replace question

What we found doing this

Three of these pages turned on the same thing, and it is the most useful habit we can hand over. A published typical range is often not a typical range. It is two scenarios, a best case and a worst case, lifted out of another guide and printed as the band a normal homeowner should expect.

It has now happened on four pages, and on three of them the publishers say so themselves. On the sump pump page, This Old House prints $500 to $4,000 as typical; those are Fixr's stated low and high scenarios, and This Old House notes on the page that its cost data came from Fixr and Angi. On the French drain page, Bob Vila prints $500 to $18,000 as typical; those are Fixr's stated 50-foot and 100-foot cases, and Bob Vila lists Fixr among its own sources.

So when a range looks generous, ask what the two ends describe. If one end is a part swapped into an existing hole and the other is a full system cut into concrete, the range is telling you about the extremes of a trade, not about your house.

The mold pages added the mirror image of the same habit. There This Old House prints $1,200 to $3,750 as typical while its own page puts whole-house work at $10,000 to $30,000, so the range is too narrow rather than too wide. Either way the rule is the same: find out what the two ends of a range describe before you use it.

Where the numbers come from

Three publishers carry this section: This Old House, Fixr and Bob Vila. A fourth name, Angi, sits behind several of them without publishing here itself. Where a figure is attributed we say to whom, and on this subject that matters more than usual, because the attributions change from page to page. This Old House cites its own research on foundation repair, Fixr and Angi on sump pumps, HomeAdvisor on slab leaks, and Angi on mold remediation. Bob Vila credits Angi and HomeAdvisor on waterproofing, on French drains and on both mold pages, and lists Fixr among its sources every time. Fixr names pricing databases, licensed contractors and industry experts, and no individual publisher. We say which is which on every page.

What connects this to the rest of the site

Water is usually upstream of foundation movement, and the water often arrives through the roof line. If you came here from our gutters section, the drainage question is the same one.

The ground itself is the other half of it. How fast your soil drains decides what a foundation has to cope with, and on a property without mains drainage it also decides what wastewater system is allowed at all. Our septic section covers that side, starting with what installing a system costs.

Questions answered